Skip to content
Emergency Plumber East Syd

Gas Fitting Eastern Suburbs

Licensed gas work: leak detection and repair, cooktop and heater connections, bayonet points, gas line extensions and compliance certificates.

Gas Fitting in the Eastern Suburbs: the short answer

If you can smell gas in the Eastern Suburbs, get everyone outside first, then call 000 if the smell is strong or Jemena on 131 909 (the Sydney gas network, 24 hours) to have the supply made safe. Finding and repairing the leak on your side of the meter is a licensed gas fitter's job: $250-1,200 on this site, including the compliance certificate, at $120-160 an hour for emergency work with no call-out fee. Cooktop connections, bayonets, gas-to-induction disconnections and new lines are quoted in writing before anything starts.

Updated 8 October 2026. 2026 reference prices; the plumber confirms the price in writing before work starts.

Gas Fitting in Sydney's Eastern Suburbs

Gas does a lot of quiet work in Eastern Suburbs homes — cooktops in renovated Paddington terraces, ducted and space heaters in Randwick family homes, continuous flow hot water bolted to the walls of Coogee flats. When it’s installed and maintained properly, it’s excellent. When it isn’t, it’s the one trade where a shortcut can genuinely hurt someone. Every gas job booked through this site is carried out by a gasfitter licensed with NSW Fair Trading, at $120-160 an hour for emergency work with no call-out fee, and every job ends with the compliance certificate that proves it was done right.

Gas leaks: the emergency side

A gas smell is never a “keep an eye on it” problem. Get everyone outside, then call 000 if the smell is strong, or Jemena on 131 909 to have the supply made safe: Jemena runs the Sydney gas network and attends leaks 24 hours a day, free of charge. A licensed gas fitter then pressure-tests the installation to find exactly where it’s leaking, rather than guessing:

  • Ageing fittings and corroded pipework — common in older homes where original copper and fittings have spent decades in salty coastal air
  • Perished flexible hoses behind cooktops and dryers, a frequent offender in tenanted homes
  • Disturbed lines after renovations — a nail or screw through a wall-run pipe can leak slowly for months
  • Faulty appliance regulators and valves

Small leaks matter as much as big ones: beyond the fire risk, a poorly burning appliance can produce carbon monoxide. If a flame that should burn blue is burning yellow or sooty, have the appliance checked.

Installation and fitting work

The everyday gas work across the Eastern Suburbs:

  • Cooktop and oven connections — including the gas-to-induction disconnections that now come with many kitchen renovations
  • Bayonet points for portable heaters, installed where you actually use them
  • New gas lines and extensions — outdoor kitchens, BBQ points, pool heaters, granny flats
  • Appliance servicing and safety checks — burner pressure, flue integrity, connection soundness
  • Gas meter relocations and upgrades coordinated with the network operator, common in terrace renovations where the meter is in the way

Sizing matters more than people expect: a gas line that was adequate for one cooktop may starve a continuous flow hot water unit added years later, producing lukewarm showers that get misdiagnosed for months. Sizing rules come from the AS/NZS gas installation standards. When a gas fitter quotes new appliances, they check the whole installation’s capacity, not just the last metre of pipe.

Compliance, strata and landlords

Every gas job in NSW requires a licensed gasfitter and, for most work, a compliance certificate. The licensed gasfitter who attends provides it as standard. For landlords and strata managers in the Eastern Suburbs the same gas fitters handle periodic gas safety checks and the documentation that goes with them — increasingly requested by insurers and managing agents.

Smell gas now? Stop reading, get outside, and call 000 or Jemena on 131 909. For everything else, book a time and a licensed gasfitter will be there with the licence, the test gear and the paperwork.

What it costs

2026 Sydney reference ranges, labour at $120-160 an hour included. The plumber confirms the price in writing before work starts.

Gas leak diagnosis + repair (with compliance certificate)$250-1,200

Full price list and price estimator →

Frequently Asked Questions

I can smell gas — what do I do right now?

Don't flick any switches on or off, don't light anything, and don't start looking for the leak yourself. Open windows and doors, turn the gas off at the meter if you can do so safely, get everyone outside, and call 000 (strong smell) or Jemena on 131 909 from there. Treat every gas smell as real until a licensed gas fitter has tested the installation.

Can any plumber legally work on gas?

No. In NSW, gas work must be done by a gasfitter licensed with NSW Fair Trading — it's illegal (and genuinely dangerous) otherwise. Every gas job booked through us is done by a licensed gasfitter, who issues the required compliance certificate for your records, your insurer and, in strata, your building manager.

Can you convert my kitchen from electric to gas — or the other way?

Both directions. Adding gas means running a correctly sized line from the meter and fitting an approved connection; going the other way — increasingly common in new renovations — means safely capping and disconnecting the gas line so the kitchen can go induction. Either way you get the compliance paperwork at the end.

First five minutes

Plumbing Emergency? What to Do Right Now

Pick what is happening. These are the safe first steps for the next five minutes, before the plumber arrives.

Burst or leaking pipe: what to do now

Stop the water first, then deal with the mess.

  1. Turn the water off at the meter. Houses and terraces: the meter is in a small box at the front boundary, often set into the front path or behind the fence. Turn the tap clockwise, or turn the lever a quarter-turn so it sits across the pipe. Units: your own stop tap is in the laundry, the bathroom inspection panel or the hot water cupboard; the building tap is not yours to touch.
  2. Keep water away from electricity. If water is near power points, lights or appliances, switch the power off at the switchboard, but only if you can reach it without standing in water.
  3. Drain what is left in the pipes. Open a cold tap at the lowest point of the home (a garden tap is ideal) and switch the hot water system off at the switchboard or the gas tap.
  4. Limit the damage. Buckets and towels under the leak, furniture and valuables moved, and photos for your insurer before anything is cleaned up. In a flat block, tell the strata manager or the neighbour below if water may reach their unit.

Don't use electrical appliances in a wet room, and don't turn the water back on to test it.

Smell of gas: what to do now

Get out first. Make every call from outside.

  1. Don't touch anything electrical. No light switches, exhaust fans or appliances, and no flames or cigarettes. A single spark can ignite gas.
  2. Turn the gas off at the meter if you can reach it safely. The gas is off when the handle sits across the pipe. Bottled gas: close the valve on top of the cylinder.
  3. Open doors and windows and get everyone outside. Pets too. Stay out until you are told it is safe.
  4. From outside, call 000 if the smell is strong, or Jemena on 131 909 for a leak. 131 909 is the 24-hour gas leaks and faults line of Jemena, the gas network for Sydney. They attend free of charge and make the supply safe. If anyone feels unwell or there is a fire, ring 000 first. Call 131 909 (gas leaks, Jemena)
  5. Then book a licensed gas fitter. The network makes the supply safe. Finding and repairing a leak on your side of the meter, and certifying the work so the gas can go back on, is a licensed gas fitter's job.

Don't go back inside to look for the leak, and don't relight pilot lights yourself.

Sewage or drains backing up: what to do now

Every litre you send down the drain comes back up.

  1. Stop running water. No flushing, taps, showers, washing machine or dishwasher until the blockage is cleared.
  2. Keep people and pets away. Sewage is a health hazard. Wear gloves and wash well if you have to touch anything.
  3. Check the overflow gully outside. It is the grated drain against an outside wall or in the rear courtyard, usually near the laundry or kitchen. Clear pot plants, leaves and mulch off it so any overflow happens outside and not through your floor wastes.
  4. Ask next door. In a terrace row the drains are often shared down the back lane. If the neighbours have the same problem, or sewage is coming up in the street, the blockage may be in Sydney Water's main: faults 13 20 90, 24 hours. Call 13 20 90 (Sydney Water faults)

Don't pour chemical drain cleaner into a blocked drain. It rarely clears a sewer blockage, and it is dangerous for whoever opens the pipe next.

No hot water or leaking tank: what to do now

A leaking tank is urgent. A cold shower is usually a repair, not a disaster.

  1. Leaking tank? Turn off its water supply. Close the tap on the cold-water pipe going into the unit. On a rooftop or balcony unit in a flat block, tell the strata manager too.
  2. Turn off its power or gas. Electric: switch off the hot water circuit at the switchboard. Gas: close the gas tap on the pipe to the unit.
  3. No leak, just cold? Electric: check whether the hot water breaker has tripped. Gas: check that your other gas appliances work and whether the pilot light is out; relight it only by following the instructions printed on the unit.
  4. Read the label. Note the brand, model and size printed on the tank. It lets the plumber quote a repair or a replacement before arriving. Near the beach, a unit over about ten years old is often cheaper to replace than to keep repairing.

Don't block or cap the relief valve that drips from the side of the tank. It is a safety device.

Overflowing or blocked toilet: what to do now

Stop the water going in before you do anything else.

  1. Turn off the tap behind the toilet. It is the small tap on the wall or floor beside the cistern. Turn it clockwise.
  2. Don't flush again. If the bowl is still filling, lift the cistern lid and push the outlet valve down, or lift the float.
  3. Mop up straight away. In a unit, tell the strata manager or the neighbour below if water may reach their flat.
  4. Check the other drains. If the shower or floor waste gurgles or backs up as well, the blockage is in the sewer line: follow the sewage steps.

Don't keep plunging once water reaches the rim, and don't use chemical cleaners.

General guidance only. If anyone is in danger, ring 000.

Need a Plumber in the Eastern Suburbs?

Tell us what's happening. Requests are received 24 hours a day, 7 days a week, and a licensed local plumber replies as soon as one is available.

Call now Book a plumber